Anti-Pass-Back

I. Single-door

Available Access Mode:

B. Card only / Card or PIN / FP or Card or PIN

One Slave WG Reader (Option)

One Host RS-485 Reader (Option)

1. ACC995 anti-pass-back setting

a. Enable device
Access programming mode → 4. Parameter (2) → 7. Anti-passback → Input: 1 or 2 Enable/Disable Anti-pass-back: 1. Yes, 2. NO → Input: 1 or 2 as indoor or outdoor reader: 1. Indoor, 2.Outdoor

b. Enable card user
By ACC995 hardware
Access programming mode → 1. Add/Delete → 9. Antipass Group → Input 5 digits start address: 00001~01023 (User address) → Input 5 digits end address: 00001~01023 (User address)

By 701Client software

G.

F.

E.

D.

C.

B .

A.

A. Tick the anti-pass-back function

B. Press the Tool icon and select Card Copy

C. Input a range of user address you want to use the same setting. For example: Copy data of User address (number) 00001 to 00020

D. Tick the setting you want to copy to other user
Access Mode including

E. Press Yes

F. Save

G. Exit the User Card Edit window

C.

B.

A.

A. Press the “Download” icon on the tool bar of 701Client

B. Tick the target control you want to download

C. Press “User Card” to download all user data to target controller

1. ACC950 anti-pass-back setting
(As same as ACC995)

2. ACC900

a. ACC900 anti-pass-back setting

(1) Device enable

Access programming mode → 20*128# please refer to “20*DDD#” function default value for additional function value

(2) Card user enable

Access programming mode → 26*SSSSS*EEEEE*1# (i.e. User address from 00001 to 00005 enable the anti-pass-back function: 26*00001*00005*1#

b. ACC900 access mode setting

(1) Card or PIN
Access programming mode *123456# or *Master Code# (If already changed) → 12*UUUUU*PPPP# (i.e. User address: 00001 and PWD: 1234, input 12*00001*1234#)

(2) Card and PIN
Access programming mode *123456# or *Master Code# (If already changed) → 13*UUUUU*PPPP# (i.e. User address: 00001 and PWD: 1234, input 13*00001*1234#)

B. PIN only

One Slave WG Keypad Reader

One Host RS-485 Reader (Option)

C. Card and PIN

One Host RS-485 Reader (Option)

One Slave WG Keypad Reader

II. Dual-door (For ACC900 only)
Normally used on parking lot system. ACC900 will become a controller and be hided/installed at the control center.

Two Slave WG Readers

One Host RS-485 Reader

ACC900WR WG format setting

WG Format Wire Color	WG34	WG34+4
Yellow	Close to GND	Close to GND
Brown	Open	Close to GND

III. Multi-door (Under ECL-ACC1000)

Each 18 readers of ACC1000 (16 RS-485 readers + 2 WG readers) could be designated as indoor reader or outdoor reader. For example: 4 indoor readers but 14 outdoor readers.

B.

CH1: 8 Units of Slave RS-485 Reader (Node 1 to 8)

CH2: 8 Units of Salve RS-485 Reader ((Node 9 to 16)

Card Only /Card or PIN

Two Slave WG Readers (Option)

Node: 17 to 18

C. PIN Only
Card and PIN